HOW TO PROGRAMME YOUR Samsung 9500
Switch your Sammy off at the back BEFORE you program the EMU in!
After Sammy has cooled down a bit [say 2-3 minutes] switch it on at the back and keep it on Standby.
Now start the STUDIO 1.2 [or 1.3] by Maestro MAHDI and go to DSR FW Loader and Send FW, then choose the Emu [now 8.0] and Open -> to put the EMU in. Wait for the clock on Sammy display, do not rush!
NOW PUT THE RAM.bin IN
Now put your Sammy to Standby, and then put the RAM.bin file [with all the other keys] in [oys or Cruiser ], then start your Sammy via remote. All working fine .
HOW TO GET YOUR AU TO WORK
Using your remote, start your Sammy from Standby and do a RESET OF EMU by pressing 0 + Menu on your remote, quickly in succession! Then go down to RESET TO EMU DEFAULTS and press the OK button on your remote.
Sammy will switch itself off now. Use your remote to start it from Standby.
Go to the EMU MENU [by pressing 0 + Menu in quick succession] and you will see the following configuration:
EMU - ON
EMM - ON
Sharing Mode - HSIC - that's for Humax CS [change to the protocol you need, when using CS; SSSP DSR for GBox and
DSR for Sammy original]
DCW Delay - experiment to see which setting here gets you a better result
RS232 Delay - as above, see which setting here gets you a better result
emu si key binl-am luat de pe crosat