Register

Welcome to the RDI-Board Community.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.


Donate Now Goal amount for this month: 100 EUR, Received: 100 EUR (100%)
Donate to support this site...

Results 1 to 4 of 4
  1. #1
    Junior Member Teacher
    RDI - Board Default Avatar

    Join Date
    Apr 2006
    Location
    DUBAI
    Posts
    152
    Posts Thanks / Likes

    Default Problem, I am not able to solve


    I am using PCI - SHINESTAR HS-DTV Hs-1020 (Red) card and using four dish antennas (Hotbird; Nilesat; Insat 4B and Insat2e,3b (C-Band)). For nearly two years it went good; but now I am facing strang problem that I am not able to solve;

    While all the four dishes connected, Insat 4B only I am getting; If I disconnect Insat 4B, nothing I am getting; If I diconnect Insat 4B and Insat 2E3b, I am getting Hotbird and nilesat in good;

    I changed diseqc switch but the same problem is there; Which version diseqc I have to use?

    Thank you

  2. #2
    Platinum member Expert
    Join Date
    Jun 2004
    Location
    29°20'N 47°59'E
    Posts
    5,711
    Posts Thanks / Likes

    Default

    well... that's strange. ordinary 4in-1out disecqs should work.
    HP-Compaq DC5000 MT 1.5GB RAM
    Debian Squeeze with Smargos
    CCcam 2.1.4

  3. #3
    Moderator Expert
    Join Date
    Jan 2006
    Location
    Africa-Kenya-Nbi
    Posts
    3,108
    Posts Thanks / Likes

    Default

    What about your diseqc switch settings on the decoder are they
    correct as was before.
    Do the set up again while putting them in one at a go.

  4. #4
    Junior Member Teacher
    RDI - Board Default Avatar

    Join Date
    Apr 2006
    Location
    DUBAI
    Posts
    152
    Posts Thanks / Likes

    Default


    I found LNB of Hotbird is fault and I changed the LNB. Now I am getting good quality of signal. Now I have to check the others.

    Thank you

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back to Top