acum trebuie sa incarci .urt-ul pt acest tip de decodor....
cauta la sectiunea strong files .... arhiva loaders....
o descarci si urmezi pasii :
To patch an virgin SRT6xxx receiver you must follow this steps :
1. connect the PC and the SRT6xxx using a null-modem serial cable
2. unplug the receiver, press CH-DWN and keep it until you plug in again the receiver
3. run BootLoader and perform CONNECT , this will replace the original boot
4. perform again step 2 and run ApplicationLoader, load the application (6xxx.urt) and upload the application
5. perform again step 2 and run PatchLoader , load the patch (patch.bin) and upload the patch
6. perform again step 2 and run PatchLoader , load the keys (keys.bin) and upload the keys table
7. start the receiver normally
TO INVOKE THE ONLINE KEY EDITOR TOOL
The online key tool will be used to view the keys present or the user will be able to add or delete his own key.
a) Follow the route
[ Menu Key -> Installation -> System Set-Up -> System Imformation ]
such that the firmware firmware version is shown.
b) Remaining there please Press the following keys in sequence
So the sequence "4225" will invoke the WeakSoft Editor for further use.