New orignal firmware from ToH,PH team

Due to a combined software/hardware bug there are problems with some Dolby Digital amplifiers
during the initialisation phase. We have been able to solve this problem (at least with our DD test
amplifiers by Yamaha and Denon) by applying a software modification which can be used starting
from version 3.4 of ToH firmware. Unfortunately, it is still necessary to solder a simple wire link as
described below. This should be done only by experts in using a very fine soldering tip. We would be
pleased if you could communicate your experiences with this solution to us.
AC-3 burst initalisation (ToH/Config) must be set to OFF!

- ORF Dolby Digital Fix