use Hyper Terminal (You know that is
part of computer operating system e.g.WinXP)
Folow and use this procedure:
Before start your work,save your settings(channel list) on hard disk,prepare
and conect serial rs232 ("pin to pin" cable), then reset receiver to factory
default.Now GO AHEAD.Run Hyper Terminal
Step1:COM port setting
1. Bits per second : 115200
2. Data Bit : 8
3. Parity : NONE
4. Stop Bit : 1
5. Flow Control : Hardware
Step2 Preparing Hyper Terminal and sw
2. SEND FILE ....
3. BROWSE >search file e.g. DSR9500EMU vXX.bin)
Dont touch "Send" in this moment.
Now out of receiver yours CAM`s and CARD`s (very important!)
NOW all is ready!
1.Turn off main svitch(back side)
2.Press right cursor on front panel(receiver) name=Volume Up
3.Turn main switch on, you see in display 3-01,in H.T. window you see:
Samsung brand....etc...etc...OSD initializing...3-01 Loading CCC...and then
4.Now press SEND and process start automatically.(see attach picture no1)
5.Final window is ..(see atach picture no2)
6.Your receiver reboot automatically.
6.New sw is in your receiver.
I hope that you know how put settings and key in
When you write keys in receiver put first your card with conax emulation(emu
not work without this card).
If you have standard Viaccess(ART) gw card or other card with new Via2 keys
previous is no need
Thats all my friend,good luck!