Register

Welcome to the RDI-Board Community.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.


Donate Now Goal amount for this month: 100 EUR, Received: 100 EUR (100%)
Donate to support this site...

Results 1 to 2 of 2
  1. #1
    Member Mentor
    RDI - Board Default Avatar

    Join Date
    Oct 2004
    Location
    Bucuresti
    Posts
    576
    Posts Thanks / Likes

    Default NEW - Interfata Phoenix USB

    Am proiectat si am realizat o interfata Phoenix pe USB.

    Caracteristici:
    - Foloseste pentru partea de comunicatie USB un chip FTDI- FT232, deci este recunoscut automat de PC si DM800
    - dimensiune cablaj: 65 x 80 x 10 mm
    - clock: 3,579mhz, 6 mhz, custom (un loc gol, pentru un al treilea quartz, dupa nevoie), selectabil din jumper
    - fara alimentare externa, se alimenteaza din portul USB
    - alimentare card: 3,3 sau 5 volti, la alegere din jumper
    Am facut teste pe PC, cu diferite carduri, pe care le-am avut la indemana, din punct de vedere hardware totul este ok.
    Urmeaza un mic tunning la cablaj si sper ca peste vreo saptamana sa pot scoate cateva bucati la gata.
    Rog, de la cei care sunt la curent cu subiectul, sugestii, sfaturi etc.
    DM800, DM7020, DM500S, KSC-570, SRT4355EVO, Conserve diverse, SkyStar 2 Rev 2.6, Offset 1.2, H-H Strong, Twin Inverto 0.3, 53E - 30W, etc....

  2. #2
    Member Mentor
    RDI - Board Default Avatar

    Join Date
    Oct 2004
    Location
    Bucuresti
    Posts
    576
    Posts Thanks / Likes

    Default

    Iata si cum arata!

    http://www.4shared.com/photo/w-Two9Z...by_Gelvis.html

    I-am pus si un conector cu patru pini, pentru legatura direct pe PC Motherboard.
    DM800, DM7020, DM500S, KSC-570, SRT4355EVO, Conserve diverse, SkyStar 2 Rev 2.6, Offset 1.2, H-H Strong, Twin Inverto 0.3, 53E - 30W, etc....

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Back to Top